• No product in the cart

How to use pitara tips

How do I know what kind of PITARA is good for me?

WOODEN pitara Best for those of you that like to roll a nice cone shape. GLASS pitara Best for those of you that like straight, thin and stylish rolling.

What comes inside the box of the PITARA?

Each box contains one PITARA, one PITARA cleaner and a PITARA user guide.

How often should I clean my PITARA?

For a long lasting PITARA we recommend cleaning the PITARA after each use, this way you can assure the maximum life span of PITARA.

How long can the PITARA last?

If you clean PITARA after each use and maintain it properly, PITARA will last for at least 40-50 rollups.

Where can I find more information about your products?

ust go to our more info section at the SHOP to read more about each of our products.


How to Roll a Pitara Tip in 5 Steps.

Step 1

Start rolling as you normally would, by placing your favourite brand of tobacco on a Rolling paper, leaving space for the Pitara on one side

step 2

Place the Pitara on the Rolling paper, right against the tobacco.

Step 3

Keep rolling as you normally would, taking care that the Rolling paper gets rolled tight around the Pirata so that it doesn’t slide out

Step 4

Lick, seal, light up and enjoy

Step 5

Remove the Rolling paper from the Pitara by scraping it off with your thumbnail. The use Pitara cleaner as needed.


Take of the FAP pipe from the cover. Pitara on one side.

Fold panel B (and panels C and G) straight up. Fold panel C (and panel G) back to the left and parallel to panel a (to form “Z” with panels A,B and C). This is a difficult fold. Take your time!!! Fold panel D (and panels E and F) straight up.

Fold panel E (and panel F) over to the left and parallel panel A (to close them stem). Fold panel F straight up. Fold panel G straight up.

Fold panel J straight up. Fold panel H (and panel I) straight up. Fold panel I over to the left and parallel to the panel A (to close the bowl).

Fold panel K (and panel H,I and J) straight up and engage the tab of panel I into the slot in panel E. Fold panel G back a little to hold the bowl assembly in place.